General discussions about our craft and industry.
  • User avatar
  • User avatar
  • User avatar
  • User avatar
  • User avatar
User avatar
By Rhonda
#12161
Just want to say thanks again for your courses and videos.
I watch a how - to Online how to do a boat seat cover. I was so confused by the time I was done.
Nothing like you do. Your good !
John liked this
User avatar
By John
#12164
Thank you so much Rhonda! Its so great to hear that the courses have been so helpful!
User avatar
By Roothawg
#12169
We are just getting started, but so far we are enjoying the videos. Hoping my skills will grow to keep up with the videos.
John liked this
User avatar
By John
#12176
Thanks @Roothawg! Let us know if you need any help along the way.
User avatar
By John Long
#12180
I have been around the auto trim industry much of my life but never made a living from it. Even though I had been doing my own upholstery for Years, I came across John's videos on door panels on YouTube. I enjoyed watching them and told my wife "I think I would like John's complete course for my birthday present."

i would, and do, highly recommend John's courses for anyone that is not an expert in this field. They are not only thorough but contain many tips that can make a difference in your results. The cost is negligible when you compare it to the labor to do just one interior. Nothing will take the place of practice when developing any skill but having a great foundation to build on is priceless.

John's courses provide that.

John Long
John liked this
User avatar
By Ddedman
#12201
Finally found time to finish the videos in entirety. Very good presentations. Thanks to John for putting them together. For me it helped me build confidence. Thanks again.
John liked this
User avatar
By John
#12217
Thanks @John Long and @Ddedman I really appreciate the great comments about the courses. It makes all the hard work worth while.
John Long liked this
Top stitch question

make sure to do relief cuts on the curves and corn[…]

are your relief cuts on the stitch side. not on th[…]

Good information. I'm going to check this foam pl[…]

For diamond pattern I just staple the edges about […]