• User avatar
  • User avatar
User avatar
By BigRig
#10413
I would like to make a kite and just wondering if anybody ahs ever made one and if there is a supply place for the framework.
Click Here to Remove Ads
User avatar
By Revv Up
#10414
I have made a Flexifoil copy once, was a ton of work and I got to find out why good kites are so expensive, I also have quite a few Revolution kites that I’ve had to operate on every now and again. I put a ton of hours on them and eventually the spars wear through the leading edge.

These guys should have raw spars and their probably relatively close to you https://www.canadiankitecompany.com/
John liked this
Click Here to Remove Ads & Support the Forum!

I had the 78-1 for a few weeks and then sold it. […]

Welting Feet??

I would think the only case for toothed welting fe[…]

alignment marks on curves

@trimmer2 , Thank you for the advice.

1953 Ford Crestline

That is an awesome first project! It is coming al[…]