• User avatar
  • User avatar
User avatar
By BigRig
#10413
I would like to make a kite and just wondering if anybody ahs ever made one and if there is a supply place for the framework.
User avatar
By Revv Up
#10414
I have made a Flexifoil copy once, was a ton of work and I got to find out why good kites are so expensive, I also have quite a few Revolution kites that I’ve had to operate on every now and again. I put a ton of hours on them and eventually the spars wear through the leading edge.

These guys should have raw spars and their probably relatively close to you https://www.canadiankitecompany.com/
John liked this
Single Faced Basting Tape

Drop the single face and just enter basting tape. […]

I have a Pfaff 545 and 1245 which use the same bob[…]

Do you have a picture of the corner? Trying to und[…]

The Padded Cell

nice job! :grin: