- Sat May 13, 2023 1:38 pm
#16372
Now that I got it finished, I thought I'ld share my cutting/sewing table set up.
This thing is a tank.. 5 foot by 10 foot and weighs over 500 lbs. 1 1/2 ' solid top with 4 tanker desks as the base.
And here's the roll holder I came up with. Made from scraps of 6061 T6 I had laying around at work.
I didn't quite get 60"s between the 2 as I did want the mounts to be completely under the table. As such, I wont be able to hold a 60" roll of canvas and my prior questions about diameter should be a non issue as it sit about 11"s from the center of the notch to the tables edge.
I also made it easily removable so I can have clear access around the table when I need to work.
This thing is a tank.. 5 foot by 10 foot and weighs over 500 lbs. 1 1/2 ' solid top with 4 tanker desks as the base.
And here's the roll holder I came up with. Made from scraps of 6061 T6 I had laying around at work.
I didn't quite get 60"s between the 2 as I did want the mounts to be completely under the table. As such, I wont be able to hold a 60" roll of canvas and my prior questions about diameter should be a non issue as it sit about 11"s from the center of the notch to the tables edge.
I also made it easily removable so I can have clear access around the table when I need to work.