• User avatar
  • User avatar
  • User avatar
User avatar
By John
#12570
@John If the hand stapler you have accepts the 9mm crown width it should work.
By Rug Dr.
#12907
I've had a BeA for years, 1/2 crown. A couple of years ago I was doing a seat that the short nose would not work. I picked up a Fasco long nose 3/8 crown (71). It's my go to gun, the old short nose is collecting dust.
John liked this
User avatar
By Roothawg
#13023
I just ordered this one, but I am trying to source staples as some of the others have said.



What do I look for? I am at this part of the series in the videos. Planing on building some door panels over Memorial Day vacation. What size is the most standard? I know on the video you said 1/8" are hard to come by.

I found 1/8" on Amazon. Not sure if these are right or not?





Thanks,

Root
User avatar
By John
#13034
@Roothawg You purchased a fantastic stapler that will last your lifetime! The staples you found on amazon will work great for automotive door panels. You can also purchase staples form albrights supply for a good price as well.

Your stapler takes 3/8 crown staples. Galvanized works fine on anything automotive and furniture. On outdoor conditions like boats you'll want to get stainless staples. More expensive but worth it!
Roothawg liked this
Single Faced Basting Tape

Drop the single face and just enter basting tape. […]

I have a Pfaff 545 and 1245 which use the same bob[…]

Do you have a picture of the corner? Trying to und[…]

The Padded Cell

nice job! :grin: