• User avatar
  • User avatar
  • User avatar
By glennco
#16810
Hello, newbie just got my Juki1541S set up very excited to learn a new craft my question is what speed should I set the servo motor to? any help would be greatly appreciated Glenn.
User avatar
By WILD BILL
#16812
For just starting out, set it as slow as you can/ can tolerate. Speed it up a little at a time as you gain skills and confidence.
Adam12 liked this
By klackey28
#16844
I just got the same machine and sometimes i accidently start out too fast. I've often thought it would be nice to slow it down but didn't know it was a possibility. How is it done?
By fibersport
#16845
A smaller pulley on the motor is a cheap and quick way, the other is a speed reducer which is a bit more expensive. Benefit to the speed reducer is while it slows the machine down, it increases the torque. There are tons of posts on building and/or installing speed reducers.

@WILD BILL I did some seats with the customer o[…]

corners are always an interesting subject. Im look[…]

Additional foam

Yes , thats albrights. The good thing about usin[…]

Singer 111G 156 ha ha. I almost have this timed bu[…]